![]() ![]() I followed the instructions perfectly as far as I can tell. The drivers install without error, and even Freestyler recognizes it as a valid controller, but my dimmer is not receiving any DMX signal at all. I am using WinXP, and tried installing the drivers from the link provided, as well as the drivers that came on the disk for RS485 WinXP, and made certain I was using a straight cat5 cable. So, I got this one here:, and it is not sending the DMX signal at all. I have tried all of the troubleshooting guides, but nothing seems to fix it. Sometimes it only lasts minutes, and sometimes for days, but ultimately, it stops working and I have to unplug the USB and re-plug it to get it to start working again. The only problem is, it keeps freezing intermittently, and stops sending a DMX signal. marks the end of support for all ENTTEC USB devices for DMX Output. M6 (with installed upgrade kit) End of ENTTEC USB support. The ONYX OS is supported on the following hardware: NX2, NX4. I first got the USB to RS485 Module, and got it to work. All ONYX systems are now able to utilize the same Operating System. I am having some issues with both of them however. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |